中国は、さまざまな種類のデバイスの大量生産の最先端と見なされている国です. 大量生産により、強力で安定した経済を維持できます, したがって, 生産は継続的で止まることなく. 今日、ほとんどすべてのデジタルビジネスで非常に一般的になっています, 中国以外の企業の多く, 大量生産を目指しますが、この国と同じ効果でそうしないでください.
違いは、適用される人員に関するものではありません, 達成された研究も. 中国, 常に最前線に入ろうとしている, and for this it seeks to obtain the most advanced machinery to be able to produce quickly and effectively.
Seeing this, we understand why a simple procedure that is normally delegated to humans can be accelerated in a gigantic way using the appropriate machinery.
自動スクリュー駆動機
The use of 自動スクリューフィーダーマシン allows the screws to be ready to be placed without delay. In addition, these machines in addition to ordering them, perform the counting of the pieces to minimize their waste, something that does not happen with the human factor.
自動ネジ供給機 is an assembly equipment manufactured for the task of supplying screws and screws in the field of automation, assembly of components, electronic circuit boards, machinery, smart phones, electricity Wireless phones, computers, navigation screens, sound boxes, cameras, small devices, toys … The machine has the function of quickly and accurately aligning screws. The machine can be used to classify and supply screws for assembly for different types of screw heads …and so on.
On the other hand, 多くの場合 自動スクリューロック機 works tirelessly and with a fixed working time. With just placing the pieces to be screwed in the base, the machine will perform the work for which it was programmed, with only one possibility of 1 per thousand error. This translates into rapid production, which with the right staff can multiply the dispatch speed of this area by 1000%.
How these two machines translate to profitable production
The 自動スクリューフィーダーマシン is a machine that simply seeks to accelerate the screwing process and at the same time make a count of the parts that enter the production chain. It is not a machine with a very complex job, since it is based on a device where all the screws are placed and through its operation it seeks to align and dispatch them to be screwed. The way in which this machine increases profitability is obviously by the reduction of personnel for the classification of the screws, and by increasing the speed for screwing enormously, something that is vitally important when it comes to continuous mass production.
Following this we have the 自動スクリューロック機. This machine works in a slightly more elaborate way: it needs a special programming to signal where the screwing will take place, the force and pressure to be placed on each screw must also be adjusted. This machine collaborates with profitability in a much more active way:
a- It greatly reduces the personnel destined to screw. It will only take personnel to place the pieces to be screwed and remove them once finished, the machine will do the rest.
b- The margin of error when screwing is 0.01%. That said, it is very unlikely that there will be damage to delicate components or that they are screwed out of the preset place. This translates into more mass-produced components with superior quality.
c- The screwing speed is about 10 times higher than the manual and at the same time the same amount of rest is not needed. This allows the machine to work for long periods.
With this, it is clearly seen as a process considered basic, can greatly increase profitability for the company.
For more about 自動スクリューフィーダーマシン,you can pay a visit to https://www.automatedfl.com
